This project provides information on ventilation system that will assist reader’s or student to understand about the the air condition that supply into room. The air moving towards room is called velocity which is that ...

In order to fulfill the requirement of Diploma of Engineering Technology in Helicopter Maintenance from University of Kuala Lumpur, Malaysian Institute of Aviation Technology (UniKL MIAT), we are required to make Final ...

In order to fulfill the requirement of Diploma in Helicopter Maintenance Technology from University Kuala Lumpur, Malaysian Institute of Aviation Technology ( UniKL MIAT ), we need to adapt our experiences which conclude ...

All modern vehicles today include an Engine Control Unit (ECU). This unit is responsible for the co-ordination of all sub systems of the vehicle such as the fuel ignition system. The ECU reads sensor values from various ...

This thesis is about analysing hydrophobic coating implementation on aircraft internal fuel tank surface to prevent from corrosion process. Aircraft fuel tank is normally located in the wing skin itself that is made from ...

In this research, the tensile testing methods was used to test the sustainability of the materials to determine the appropriate number of rows of rivet to be applied on the materials in order to sustain the load. The number ...

Smoke detectors/ alarms are important safety devices because of their obvious potential to save lives and property. There are two types of smoke detectors commonly available in many countries: i. One type uses the ...

The final year project aims at exposing the students undergoing higher technical studies to the thoughts and logic that must be developed to ensure that one is able to integrate his/her ideas into something concrete.This ...

The research for BIRD DETERRENT SYSTEM: MOTION DETECTION - ULTRASONIC SENSOR is a Final Year Honors’ thesis being developed from the Bachelor Of Aircraft Engineering Technology (Hons) Mechanical of Universiti Kuala Lumpur, ...

The use of Vacuum Infusion Process (VIP) in the past years has proven that it is one of the best method in producing composites. It involves a mold with a reinforcement and sealed with vacuum tubing around it. The purpose ...