5. Final Year Project : [1508] Community home page

Recent Submissions
  • GENERATOR MONITORING SYSTEM USING LABVIEW

    A diesel generator is a combination of a diesel engine with an electric alternator to generate electricity. The aim of this project is to develop a generator monitoring system using combination systems of LabVIEW and Arduino. Other than that, the air of this paper...

    See

  • STANDARD OF TRAINING, CERTIFICATION AND WATCHKEEPING (STCW) KNOWLEDGE AND AWARENESS AMONG MARINE ENGINEERING STUDENTS

    STCW is the key of studies for each marine engineering students. It is important for the marine engineering students to understand about STCW as it is the root of their studies. This research specifically examined the level of knowledge and awareness on the import...

    See

  • STUDY OF CAVITATION EFFECT IN CENTRIFUGAL PUMPS CONNECTED IN SERIES AND PARALLEL

    Centrifugal pumps refurbishment, running operation and design are strongly related to cavitation phenomena. This phenomenon may occur in both stationary parts of the pumps and rotating impeller. The current experiment concerning with cavitation detection (inception, developed and breakdown)&#x...

    See

  • DEVELOPMENT OF SOLAR TRACKER USING LIGHT DEPENDENT RESISTOR AND SERVO MOTOR FOR ELECTRICAL BOAT

    Nowadays solar is one of free source that had been used. The country that have hot weather is an advantage because it can used solar energy is main or alternative supply but solar also have disadvantages. Solar are slightly pricy and the power generation only...

    See

  • DESIGN OF A TRANSPONDER SYSTEM FOR VEHICLES TRACKING USING LoRa TECHNOLOGY

    Internet of Things (IoT) is becoming bigger for each day and is talked about everywhere technology is present. Many companies are implementing ideas and solutions bound to the IoT in pursuing technological solutions with low power consumption and long range coverage of ...

    See

  • MODELLING AND SIMULATION OF ROBOTIC MANIPULATORS WITH PD CONTROLLER USING ROOT LOCUS TECHNIQUE

    This report present the stability analysis via simulation of two axis robotic manipulator with proportional derivative controller using Root Locus technique. It is known that robotic arm manipulators face vibration condition throughout high speed process that effect proficiency of th...

    See

  • IOT - DEVELOPMENT OF SMART TRAFFIC LIGHT USING ARDUINO INTEGRATED WITH LABVIEW

    Traffic congestion problem is a phenomenon which contributed huge impact to the transportation system in country. This causes many problems especially when there are emergency cases at traffic light intersections which are always busy with many vehicles. A traffic light controll...

    See

  • IOT - DEVELOPMENT OF SMART TRAFFIC LIGHT CONTROL SYSTEM USING PLC

    This thesis is to 4 junction traffic light control system are widely used to monitor and control the flow of automobiles through the 4 junction on the road. The aim to realize smooth motion of car in the transportation routes and can give way when vehicl...

    See

  • INTEGRATION OF PROGRAMMABLE LOGIC CONTROLLER (PLC) AND ARDUINO WITH IOT TECHNOLOGY FOR MONITORING AND CONTROL MULTIPLE 4 JUNCTIONS TRAFFIC LIGHT SYSTEM

    This paper provide an open solution on method to integrate two different controller by different manufacturers to become as one integration system which will then monitor by SCADA. This paper also focus on to mix two different industrial controller on the same system&#...

    See

  • SWOT AND TOWS MATRIX ANALYSIS: A CASE STUDY ON BME LOGISTICS SDN BHD

    This research is regarding the Strengths, Weaknesses, Opportunities and Threats (SWOT) analysis carried out on a particular company, which is located in Sitiawan,Perak. In this research, the main subject that was selected was the company of BME LOGISTICS SDN BHD. The primar...

    See

Browse